### OEE Calculation without APQ

**A**vailability,

**P**erformance and

**Q**uality (A*P*Q = OEE)in order to calculate your OEE. However if this information is not readily available then it can make the task very time consuming to gather such information.

There is an alternative calculation that gives you the same answer using information that should be easy to obtain. The calculation is based on time and the quantity of finished goods that can be shipped. This article outlines this alternative calculation.

Before you can calculate you will need the following:

**Scheduled Time**for the period you are calculating OEE for. This is basically the time you planned to have a machine available. For example, you could plan the machine to be available 12 hours a day simply because you only manufacture for 12 hours a day.**Good Units Produced**is simply what quantities of product were produced for the period which meet acceptance (*i.e. the figure excludes rejects, bad product*). If the machine runs at different rates for different products then you should break out the Good Units total for each different product.**Product Cycle Time(s)**is the theoretical machine time it takes to produce excluding set-ups etc.. If you do not know the theoretical time then it should be relatively easy to go to a machine and calculate it using a timer for a short period of time (*be sure to exclude any stoppages during that timing period as all you want to do it count why it is running*). I normally try to base this on an hour (*i.e. if the line was running non-stop for an hour then how many units could I theoretically produce?*).

With the above information you can now calculate you OEE Percentage as follows:

**OEE% = (Good Units Produced / Product Cycle Time) / Scheduled Time**

__Example:__

I want to calculate my OEE for Machine 1 for last week. The machine is available during the normal working hours of 08:00 -> 20:00 (12 Hours) Monday -> Friday (5 Days).

**Scheduled Time is 12 hrs x 5 (Days) = 60 Hrs**

During that period I produced the following Good Units/Finished Goods:

789 Product A

970 Product B

** Product A has a Product Cycle Time of 50 units an hour.** This means that if the machine was running without any downtime at 100% performance and no quality loss then in theory I could have produced 789 unit in 15.78Hrs:

**Product A Theoretical Time = Good Units/Units Per Hour = 789/50 = 15.78**

** Product B has a Product Cycle Time of 60 units an hour.** This means that if the machine was running without any downtime at 100% and no quality loss then in theory I could have produced 970 units in 16.17Hrs:

**Product B Theoretical Time = Good Units/Units Per Hour = 970/60 = 16.17**

**My OEE therefore is calculated as follows:**

**OEE% = **(Product A Theoretical Time + Product B Theoretical Time) / Scheduled Time %

(15.78 + 16.17) / 60 %= 31.95/60 %= **53.24%**

This means that out of 60 Hours I have effectively "lost" 46.75% of the time (or about 28 hours). These 28 hours is a combination of availability (downtime), quality (rejects and rework) and Performance (short stoppages, reduced line speed, process weaknesses).

Labels: oee, oee calculation, overall equipment effectiveness